hinges are designed for doors 8 to 10 mm thick, especially made
of glass. They hold the door firmly without jamming in all positions
except a 15° zone on either side of the balanced self-closing
are mainly used in bathrooms, shower stalls and separation gates.
includes five hinge models:
Height x width : 180 cm x 70 or 190 cm x 95 for version "
: 8 to 10 mm
load : 31 kg/pair or 45kg for version ""
: uniquement approfondie en version ""
(�ch.1) : normal or deep in normal version, only deep in version
Nota : In standard
model the wall plate has cut-outs in bottom and top parts, PVC sealing
strips (790 02X, 790 06B) or tubular seal (790 08D) can be extended
to the hinge’s inside. It is not the case with "45"
model. In order to achieve some water tightness it is recommended
to use a deeper cut out for the hinge which offers minimum space
between glass and wall.
Separation from the support :
- Remove the leaves and counterleaves
and attach the
hinges flat on the doorjamb, making
sure they are aligned.
- Check for the presence of the
cork gaskets and install the leaves and counterleaves on the door.
- slide the clamps onto the cams
attached to the doorjamb. Level and staighten the door.
- Tighten the screws completely
(use an Allen wrench). Recommended torque : 0,25 m.kg.
- In case of an offset, compensation
plates are available (thickness 3 mm).
- Make sure there is no risk of
opening the door more than 90° beyond the balanced position.
If there is, provide a stop.
hinges are available with three finishes : chrome-plated brass,
matt chrome and gold brass. The model with wall leaf is also available
with a white epoxy (RAL 9010) or brushed chrome finish.
catalogue includes many accessories
for use in separations, shower stalls and bathrooms, e.g.:
- Shower curtain rod, pull knob,
see family 699,
- Clamps for attachment of separations,
see families 504 et 634,
- Water deflector, see family